CURRENTLY SOLD OUT

Lucky Reptile Herp Nursery II Incubator

About this product

Product Identifiers

BrandLucky Reptile
EAN4040483698024
eBay Product ID (ePID)1405201921

Product Key Features

Animal TypeReptiles
Sub-TypeTemperature Control
TypeIncubator

Ratings and reviews

4.6
16 product ratings
  • 12 users rated this 5 out of 5 stars
  • 2 users rated this 4 out of 5 stars
  • 1 users rated this 3 out of 5 stars
  • 1 users rated this 2 out of 5 stars
  • 0 users rated this 1 out of 5 stars

Would recommend

Good value

Good quality

Most relevant reviews

  • Most favourable review

    Herp incubator

    The item appears to maintain the temperatures that I have set when testing it. The built-in circulating fan ensures even temperature throughout and I have tested it against thermometers including an infrared thermometer. Temperatures measured appear accurate against the temperature I have set, and what it displays. It is good value for money and not expensive - especially considering the amount of use it should be being put to this year.

    Verified purchase: YesCondition: New

  • Most critical review

    Exo Terra and Lucky incubator

    These incubators are adequate for function but the displayed temp should not be relied on as can be out a couple of degrees. Use a internal thermometer to check correct temp. There can be a few degree temp gradient top to bottom. Main issue is the reliability. They can stop working during incubation. The fan goes but no heating or cooling. They are easy to fix as the 12v 10A relays fail. The heat contact burns out requiring the relay to be replaced. This is easy and cheap but better quality relays should be used in manufacture. One I had the peltier (heat/cool unit) failed requiring replacement. I have 3 incubators and they all have gone faulty at some point. Now have spares to keep them going as it is worrying when they fail mid term. If you buy keep your warranty handy, you may need it. It is a shame as most of the other parts of the unit seem quite reliable which is why it is fair value but poor quality when it could be far better with little effort. As a note spares to fix them are available from ebay but some of the relays are worse quality than the ones fitted. The relay spares I use are RS components 476-583. The Peltier unit is a TEC1 12705 and you will need some white thermal paste/ heatsink compound if replaced.

    Verified purchase: Yes

  • rubbish

    I have purchased two of these and both have gone wrong, but worse than just braking down they both altered the temp on there own, just one season they worked fine, then one over heated killing all the eggs, and the other one switched to cooling on its own killing 40 gecko eggs so perhaps you can understand my rating.

    Verified purchase: YesCondition: New

  • Works pefect

    Maintains temperature and i am so happy it cam earlier then expected i am new to hatching snakes but so far so good thank you. Shelves are easy to put in directions are clear and easy to read.

    Verified purchase: YesCondition: New

  • Nice and easy

    All working fine. Quality product, all as described

    Verified purchase: YesCondition: Pre-owned

  • Lucky Reptile incubator good value for money

    Very simple to use and quiet on quiet setting. Quick checks show temperature variation of +/- 1.5 deg C at 60 deg C setting. Solid feel and door closes well. Am using it as a low temperature cure chamber so no incubation being carried out

    Verified purchase: YesCondition: Pre-owned

  • Can't wait to use it snake is going to pop eggs out any day now

    Cant wait to use it snake is going to pop eggs out any day now

    Verified purchase: YesCondition: New

  • great

    great

    Verified purchase: YesCondition: New

  • if incubating reptile eggs best incubator going

    Was bit worried it wasn't holding temp at first but waited bit longer and it settled. Now incubating BD eggs and the are looking good. Contacted them and got quick response to my questions. Great product, looks so cool, very quiet, easy to use, very impressed

    Verified purchase: YesCondition: New

  • Incubator

    Happy but a little disappointed with the quality as it was very hard to fit the shelves in, no matter how you rotated them as the side seemed to be out ,which made it very difficult to fit shelves, but a part from that it seem to work ok.

    Verified purchase: YesCondition: New

More items related to this product